The original power steering systems
use a hydraulic pump to move fluid into chambers in your steering system.
Not exact matches
The system
uses ultra-efficient technology to fill the tank quickly, and a permeate
pump powered by
hydraulic energy requires no electricity to run.
The overarching idea is to
use lighter electric motors instead of the usual heavy
hydraulic pumps to control flight surfaces such as rudders, ailerons and other movable systems.
The trouble is the
hydraulics normally
used to
pump liquids from place to place, says Manu Prakash, a physics graduate student at the Massachusetts Institute of Technology.
Peacock spiders and other jumping spiders
use internal
hydraulic pumps rather than leg muscles to leap 30 times their body length.
The gas is extracted
using a method called
hydraulic fracturing, or fracking, a technique that involves
pumping millions of gallons of water laced with chemicals deep underground to blast open the shale and release the gas trapped inside.
Cornell University researchers factored in the carbon emissions over the course of natural gas's life cycle when it is extracted
using hydraulic fracturing — which includes drilling the wells, erecting the construction sites, building pipelines to transport the gas, fueling the
pumps that force the water underground, and transporting the wastewater — and concluded that natural gas is dirtier than coal.
Although LS3's propulsion system is still being designed, BigDog's
used a two - stroke, go - kart gasoline combustion engine to drive a
hydraulic pump.
The Altima
uses an electrically driven
hydraulic pump for its power steering system.
The V - 8's accessory belt spins a
hydraulic steering
pump in the S8, but the S7
uses an electric assist motor mounted on the steering rack.
The TDI
uses electrically assisted power steering, while the 2.5 - liter engine drives a
hydraulic pump.
Typically a
hydraulic pump used to multiply force that is inputted through a vehicle's steering wheel by the operator of the vehicle.
Unlike the
hydraulic pumps of conventional power steering systems, the electric motor of the electromechanical arrangement
uses energy only when the steering wheel is actually turned.
The ML now
uses electric assistance for its power steering — as opposed to a
hydraulic pump that leeches power from the engine.
Have into account two factors: oil viscosity may be much or very much higher than the antifreeze fluid (glicol - polipropylene derivates) normally
used: the radiator grille has capilare - thickness tubes and an
hydraulic circuit (
pump, filter, reservoir...) prepared for much less viscosity.
The fabric hood has been given a smooth inner lining partly to hide the hood frame and partly to reduce noise levels, while the system
uses a new
hydraulic pump that's silent in operation in place of the electric motor
used previously «We have spent a great deal of design and engineering time and expertise to ensure that the roof of the 370Z Roadster is fully integrated into the overall design of the car.
Instead, the engine was connected to two
hydraulic pumps (one for each side) that
used pipes to drive individual
hydraulic motors in each wheel.
What is it: The Volkswagen Golf Alltrack wagon
uses a 1.8 - liter turbo - four for power and comes with VW's 4Motion all - wheel drive
using a Haldex - 5 coupling and an electro -
hydraulic oil
pump.
The multi-plate clutch at the heart of the Golf R's Haldex 5 all - wheel drive system is familiar enough,
using an electro -
hydraulic oil
pump to engage and send almost 100 percent of available torque to the rear axle when a control unit deems it necessary.
Hi There, Your car's power steering system works by
use of
hydraulic pressure that runs through the
pump which is powered by the motor by a belt.
Surprisingly, the power steering still
uses the engine to
pump its
hydraulics rather than switching to an electric power steering system.
The M6's steering rig
uses hydraulic fluid pressurized with an electric
pump, allowing BMW to implement another set of Comfort, Sport, and Sport Plus settings.
The hood was totally power operated
using a combination of electric motors and
hydraulic pumps.
According to Volkswagen, it
uses the latest generation Haldex - 5 coupling, which is activated by an electro -
hydraulic oil
pump.
This system
uses a belt or camshaft driven
pump from the engine to pressurise a special
hydraulic fluid, which then powers the brakes, suspension and power steering.
For those of you who think Direct Adaptive Steering is a little too fancy - pants, the 50s comes standard with a typical electric - assist power steering system, similar to most other cars today, while the 2.0 - liter model features a
hydraulic rack - and - pinion system
using an electric
pump, although I didn't get to sample either of these.
The hybrid system
used by Nissan boosts steering input with
hydraulics, but maintains pressure
using an electric
pump, thereby avoiding sucking power from the engine.
Although throttle, steering, and braking are all in someway or another computer controlled, the CR - V's all - wheel - drive system is controlled by simple
hydraulics that
use pressure supplied by
pumps on the front and rear axles to determine torque split.
Also, the new system will be joining the present eight - speed transmission
used for Kia models with rear - wheel drive, featuring smaller
hydraulic oil
pump or a high - performance direct control valve body with 12 valves out of 20, which reduce shift times; it allows as well a 34 percent ratio increase over the six - speed automatic, improving thus acceleration and fuel economy.
It
uses a sophisticated
pump and
hydraulic system controlled by two computers to provide a combination of smooth ride and excellent handling.
It is the first time ever the Commodore will switch from
using a motor - driven
hydraulic power steering
pump to a fuel - saving electric - assist system.
Hydraulic pumps and a lightweight accumulator brake the vehicle, store the braking energy, and then
use that stored energy to provide power to the wheels.
The fabric hood has been given a smooth inner lining covering the frame and reducing noise levels, while the system
uses a new
hydraulic pump that's silent in operation in place of the electric motor
used previously.
Steering, which
uses a
hydraulic system and electric
pump, feels tuned for a comfortable, easy driving character.
Hydraulic tables are more economic pet grooming tables that use a foot - operated hydraulic pump to adjust the table's height to a comfortab
Hydraulic tables are more economic pet grooming tables that
use a foot - operated
hydraulic pump to adjust the table's height to a comfortab
hydraulic pump to adjust the table's height to a comfortable level.
In this process, water is
pumped at high pressures to fracture underground hot rock reservoirs similar to technology
used in natural gas
hydraulic fracturing.
Fracking, or Fracing as the oil and gas industry ungrammatically spells it, is short for
hydraulic fracturing, and the technology is now being
used extensively to extract shale gas, by
pumping liquids at high pressure into the rock, creating and expanding fissures.
A perhaps simpler approach is to
use wave motion to power
hydraulic pistons, as with the Sea Dog
pump developed by Independent Natural Resources Inc in the USA www.inri.us.
The wave system is based on a
hydraulic power take - off system,
using a double function piston
pump to transform the energy from the wave into water pressure that is then sent through a turbine, thus generating electricity.
Connecting and disconnecting of drill string
using hydraulic powered tongs, drill bits, drill collars racking back drill pipe into slots located on the board in the derrick and setting test
pumps down hole in a timely manner safely and efficiently for contractors and customers.
PUMPS AND METERS, Rainbow, TX 6/2012 to Present Pipefitter Welder • Lay out, fabricate, assemble, and install piping systems and fixtures • Install equipment for steam, hot water, heating and cooling systems, and industrial systems • Read blueprints to select materials according to job specifications • Plan installation sequences and thread and end pipes with a pipe bending machine •
Use cemented, wiped, soldered, chalked, or threaded joints to assemble and join piping • Secure pipes and piping systems with hangers, brackets, and clamps •
Use pressure building to test piping systems for leaks • Repair and maintain pipe systems and components and secure pipes to radiators and tanks • Select materials such as supports, hangers and
hydraulic cylinders according to each work process