Sentences with phrase «valve body»

A new valve body improves gear shift responsiveness and control, while an optimization in oil pump size aids in improving operating efficiency.

This is a transmission internal issue of trying to go into reverse and drive at the same time from a leaking valve body.

Also, the new system will be joining the present eight - speed transmission used for Kia models with rear - wheel drive, featuring smaller hydraulic oil pump or a high - performance direct control valve body with 12 valves out of 20, which reduce shift times; it allows as well a 34 percent ratio increase over the six - speed automatic, improving thus acceleration and fuel economy.

If TCC % is zero and TC SLIP ACT is less than 20 rpm, then inspect the number 7 check ball in the main control valve body for damage.

I talk a fair about VW transmission issues, and valve body failures.

Replaced valve body assembly 3.

The differences between the types are the bell housing bolt pattern and valve body assemblies.

I figured it was time to actually show you guys what a VW valve body looks like.

So i tooked the car for a Diagnostic and the guy told me that the gearbox valve body is starting to pack up!

Apart from a few external control issues, such as throttle controls and the vehicle speed sensor, failure to shift usually reflects an internal component failure such as a shift solenoid, clutch pack, valve body defect, inadequate hydraulic line pressure or leaks, and so forth.

The 700R4 kit included: the gaskets and seals, HQ clutches, forward bands, high volume filter, drain plug, and Trans - Scat valve body mod.

learn more here All new parts, including additional clutch plates • Improved valve body for firmer shifts • Direct bolt - on for Gen I Small - Block and all Big - Blocks • Does not include torque converter.

Common automatic transmission modifications include built valve bodies, aftermarket torque converters, automatic transmission fluid (ATF) coolers, additional ATF filters, and aftermarket TCUs.

Lot # 798 - This award - winning, black - on - black Barracuda is powered by a 426ci twin - plug HEMI engine and a manual - shift valve body 727 automatic transmission.

«This EFI injection system manufactured by EFI Speedmaster has eight butterfly - valve bodies measuring 52 mm each, suitable for all V8 engines; it was one of the 10 products I chose.

Finally, the GT - R's state - of - the - art suspension has been retuned with redesigned Bilstein shocks with a new valve body design and revised spring and damper rates.

Winner: MSD Performance, MSD Atomic LSTM, EFI for LS Engines Runner Up: Powertrain Control Solutions (PCS), 6 SPEED VALVE BODY Runner Up: Circle Racing Wheels Inc., ORIGINAL EQUIPMENT STYLE BILLET WHEEL

In addition there are shift solenoids in the transmission valve body and, in the scenario you are presenting, torque converter lock up controls...

Kia's development teams also incorporated a direct control valve body to allow solenoid control of the clutch directly, rather than via several control valves.

The most common would be low transmission fluid, faulty shift solenoid, valve body failure, a wiring harness fault, or a transmission control module...

car needs a new valve body and transmission for an estimated cost of $ 6,000 - a gross over estimate!

North Star Leasing Company financed our Valve Body Machine over two years ago.

The valve body will almost always have to be changed.

The valve body is what controls the fluid in the transmission.

A second but less likely fault is that one of the solonoid vales has become jammed open and allowing a circulaton of the pressure inside the valve body and not to the brakes.

and while I'm at it, would additional nylon washers (between the rubber and the valve body, not the pan) be the best idea if I was needing to add a millimeter or two to make sure the valve pointed down when the threads were torqued properly?

The valve body (housing that contains the spool valves) constantly got more complicated with shuttle valves and accumulators and other things to improve the shift quality.

My Volvo S60 T5's gearbox (aw55 - 50sn) has finally broken; it has a slipping third gear and possible clogged up solenoids in the valve body (due to it clonking into «D» mode).

Transmission fluid is directed throughout the valve body by various transmission solenoids — such as the transmission shift solenoid, lockup solenoid, or transmission control solenoid (there's also a torque converter clutch solenoid)-- that either open or close hydraulic valves to regulate fluid flow.

If you car does not go into drive or reverse, your mechanic is most likely talking about replacing the valve body inside the transmission.

As you may know, every time a gear change is required, the car's computer activates a transmission solenoid, which directs transmission fluid into the valve body to engage the...

If the vehicle already has a lot of miles on it, then it may have an issue with the valve body.

Yes you will have to remove the valve body to remove the shift solenoids.

As far as the governor solenoid, or the shift solenoids on the valve body, those are electronically controlled and so can be tested to rule...

Most of the time, this is caused by one of the valves getting hung up in the transmission valve body or one of the solenoids sticking.

It sounds like the car has a valve body issue.

Reminder: Whenever replacing the CVT assembly, TCM, control valve body or servicing the CVT fluid, the Learning Control procedure must be completed.

The cause of something like this could range from a defective vehicle speed sensor (in the transmission) to failing friction material in the transmission clutch packs to hydraulic control faults in the transmission valve body and / or the transmission shift solenoids...

Freshly rebuilt 360ci engine stroked to 408ci producing 400hp, and mated to a 727 TorqueFlite transmission with reverse manual valve body and 2500 stall converter.

Every time a gear change is required, the car's computer activates a transmission solenoid, which directs transmission fluid into the valve body to engage the correct gear.

To improve the 8AT's fuel economy, Kia engineers significantly reduced the size of the oil pump (the main source of power loss in an automatic transmission) and simplified the structure of the valve body.

The valve body side cover acts as an internal expansion tank, holding the excess oil until it is required and then returning it to the sump when needed.