Sentences with phrase «vehicle speed sensor»

When the cruise control is activated laser sensors in the front grille area are used, in conjunction with vehicle speed sensor inputs, to detect approaching vehicles in the same lane of traffic.

On rear wheel drive vehicles the speed sensor may be found on the output shaft of the transmission or located within the rear differential.

It sounds like you have a bad vehicle speed sensor.

It also uses vehicle speed sensors to determine how much power to apply to each wheel in an effort to maintain efficient traction and vehicle speed and stability.

My car has the P0462 (Fuel Level Sensor low input) P0500 (Vehicle speed sensor circuit fault) but both the speedometer and the fuel gauge appear to be working normally.

As you know, the transmission control module has various sensors such as vehicle speed sensors, wheel speed sensors, throttle position...

The cause of something like this could range from a defective vehicle speed sensor (in the transmission) to failing friction material in the transmission clutch packs to hydraulic control faults in the transmission valve body and / or the transmission shift solenoids...

Electro - magnetic vehicle speed sensors, one of which is located near each the wheel, send data to the ABS control module.

If you replaced the tail shaft seal behind the yoke and had to remove the driveshaft, then it is possible that the transmission vehicle speed sensor VSS is not installed correctly or the harness has been damaged.

I'm trying to read the Vehicle Speed Sensor (VSS) on my 2005 Honda Accord from the cruise control port (port 14P, located behind the steering wheel)-- when the cruise control unit is not attached.

It may be an indication these systems are failing (fuel level sensor and vehicle speed sensor) and might need to be replaced in the future, but no big deal right now.

When taken to the shop they had replaced the throttle position sensor, the egr valve gasket and the egr valve, the vehicle speed sensor, the distributor and the cap and rotor, the knock sensor, and the spark plugs.

The possible causes that contribute for this code to appear are: The vehicle speed sensor (VSS) is not reading properly There is a broken or frayed...

P0500 is a general OBD - II code that indicates a malfunction has been detected in the vehicle speed sensor circuit.

The code P0500 is in reference with the vehicle speed sensor.

Stability Enhancement Coverage includes hydraulic unit for ABS and 4 - ETS systems, charging pump, pressure reservoir, control module, and vehicle speed sensors.

If diagnosis is not performed, the vehicle's speedometer may be replaced due to it not working only for the vehicle speed sensor to be the cause.

Next, the scan tool will be used to check if a vehicle speed sensor (VSS) signal is present at all when driving.

The ECU uses the information from the vehicle speed sensor to display the proper speed on the speedometer.

The P0500 diagnostic trouble code tells us there is a fault found with the vehicle speed sensor.

Depending on the year and drive type of the vehicle, the location of the vehicle speed sensor can vary greatly.

Disconnect the vehicle speed sensor connector.

The vehicle speed sensor is located in the output shaft housing and controls the speedometer.

The vehicle speed sensors are calibrated based on OEM wheel / tire diameters.

The VSS (vehicle speed sensor) buffer is located on the drivers side near the ECM.

-- Vehicle Speed Sensor 3.

Coverage includes hydraulic unit for ABS and 4 - ETS systems, charging pump, pressure reservoir, control module, and vehicle speed sensors.

If the speedometer is not working but the rest of the instrument cluster is, the issue is probably the vehicle speed sensor.

There could be a wiring issue with the vehicle speed sensor from the computer to the speed sensor pigtail.

Apart from a few external control issues, such as throttle controls and the vehicle speed sensor, failure to shift usually reflects an internal component failure such as a shift solenoid, clutch pack, valve body defect, inadequate hydraulic line pressure or leaks, and so forth.

P0608 means there is an malfunction in the vehicle speed sensor A control module often due too faulty speed sensor or shorted electrical wiring.

Shift points are controlled by vehicle sensors such as the vehicle speed sensor and throttle position sensor.

It uses a combination of laser sensors in the front of the vehicle and vehicle speed sensors to detect oncoming objects, which present the threat of a frontal impact.

Other possibilities are faults in the vehicle speed sensor and external controls such as the throttle position sensor.

Typically when the speedometer just stops working like that it is due to a failure in the vehicle speed sensor.

Check the vehicle speed sensor (VSS) on the transmission and see if its unplugged.

Speedometer correction was accomplished using a Dakota Digital SGI - 5C to modify the vehicle speed sensor signal.

[2] The ECM is a type of electronic control unit (ECU), which is an embedded system that employs software to determine the required throttle position by calculations from data measured by other sensors, including the accelerator pedal position sensors, engine speed sensor, vehicle speed sensor, and cruise control switches.

Input signals from the throttle position sensor, vehicle speed sensor, and engine load sensors (among other things) provide the PCM with data which is calculated to determine which propulsion type is appropriate for conditions.

We're not quite sure why the automaker decided to highlight things like the vehicle speed sensor on this graphic; we're pretty sure every car has one of those.

In 2003 Ford revised the 4R70W transmission with a stronger ring gear that had 24 lugs, as opposed to 6, for the output shaft sensor (OSS) to read off of, a new torque converter, a revised front pump assembly, and a vehicle speed sensor (VSS) that compliments the OSS to improve shift quality and efficiency.

Or the vehicle speed sensor that was moved from the removed ABS system to the transfer case tailshaft by adding an OEM Toyota speed sensor and integrated it into the existing wiring harness by re-pinning the factory harness.

ANSWER: The vehicle speed sensor signal changing value is one possibility.

Data from the four vehicle speed sensors is calculated by the Powertrain Control Module (PCM), which controls the all - wheel drive system.