Sentences with phrase «voltage signal»

A voltage signal refers to an electrical signal that carries information in the form of varying voltage levels. It is a way of transmitting data or conveying messages using different voltage values. Full definition
The sensor element then sends voltage signals...
The thing that surprises me is the very low voltage signal, because the engine coolant temperature shows that the engine is quite warm (which it should be after 9 minutes of running at 4000 RPM), so regardless of the O2 heater malfunction that lambda sensor should be hot and triggering the ECU to run in closed loop (which it clearly isn't).
Computer monitors radiate low - voltage signals from their power cords which allow people with sophisticated monitoring equipment to capture and reassemble the images on your monitor.
Expanding and contracting rapidly according to the applied voltage signal, the diaphragm will then emit sound.
So when the throttle plate shaft rotates, a wiper inside the TPS also moves (along a curved resistor) and is able to send a variable voltage signal to the ECM.
As the crankshaft rotates, the sensor produces a pulsed voltage signal, where each pulse corresponds to the tooth on the reluctor wheel.
It uses a low voltage signal that minimizes any distortion.
«As soon as we applied the higher - voltage signal, the system reconfigured itself, inducing a topology that propagated across the entire chain of resonators allowing the signal to transmit without any problem,» said A. Khanikaev, professor at The City College of New York and co-author in the study.
These transport both energy and torque and thus are able to induce a voltage signal in adjacent metal thin films.
By means of material - dependent measurements over a wide temperature range and with a varied thickness of the employed magnetic material, a direct correlation between the amplitude of the voltage signal and the intrinsic properties of magnons was identified.
It can be helpful to see the voltage signal where a failure of the transistor pull all the way ground intermittently is the most common failure.
If the voltage signal is positive, this indicates that the positive multimeter probe is connected to the signal wire and negative probe is connected to earth.
If the voltage signal is negative, the multimeter probes have been connected in the opposite sense, so the negative probe is connected to the signal wire, while the positive probe is connected to earth.
As the engine in your pickup or van idles (and the throttle plate is closed), the throttle position sensor sends the ECM a voltage signal of about.9 to 1 Volts.
If the voltage signal reading of the manifold absolute pressure (MAP) sensor sends a voltage signal to the PCM that does not coincide with the voltage signal that is sent from the MAF sensor, the P2281 diagnostic trouble code will be stored and the check engine light will come on.
This information is sent through this wire and delivered to the powertrain control module (PCM) as a voltage signal.
The PCM will then make changes to the delivery of fuel and the spark timing based on the information that it receives through this voltage signal.
This voltage signal carries information regarding the pressure and flow of the EVAP system.
When this voltage signal does not fall within the predetermined voltage specifications set by the manufacturer, the PCM will store the P2422 diagnostic trouble code and the Check Engine Light will come on.
The powertrain control module (PCM) receives a voltage signal from the vent valve control circuit.
P0689 means that the relay control switch to the PCM is sending a voltage signal that not normal due a defective PCM, battery or electrical issues.
A P0689 trouble code signifies that the relay control switch to the PCM is sending a voltage signal that is out of the range of manufacturer specifications.
a b c d e f g h i j k l m n o p q r s t u v w x y z