Replacement Center Caps for large number of Genuine Volkswagen Factory and Accessory Wheels with exposed
wheel bolt holes.
Not exact matches
You'll need to know the diameter (in inches) and width (also in inches, often written with a J - so 4J x 14 would be a 4» x 14»
wheel), the PCD (pitch circle diameter, or
bolt pattern), which is stated as NxM, where N is the number of
bolts and M is the diameter in mm of a circle going through them all, e.g. 4x100, the centre bore (the size of the
hole in...
It then lifts and aligns the
wheel with the
bolt holes, putting it in position for the human worker to finish by tightening with an impact wrench.
I can't find a suitable image and don't fancy removing a lug just to take one - imagine a bare
bolt similar in length to these lugs sticking out from a
hole in the
wheel where the nut should be.
Up front the «over-fenders» are a two part item that add 30 cm to the Aventador, one section is
bolted onto the front bumper while the second section goes above the
wheel and in front of the door, some really exact fitting is needed so you don't mess up those trademark upward opening doors, once fitted at exactly the right spot you'll have to drill
holes into the fender, apply a rubber strip between the add - ons and the original fender and
bolt everything down.