In Antarctica's cold, where fish have natural antifreeze in their blood, McClintock accompanied other researchers as they angled for giant Antarctic toothfish by dropping a 450 - meter - long line through a meter -
wide hole drilled in the sea ice about five kilometers offshore.
Not exact matches
April 30, 2018
Drilling Program at Millennium Cobalt Project Successfully Hits
Wide Cobalt Mineralisation in Every
Hole and Continues to Confirm the Size of the Known Mineralised Area
A
wider gold intercept of 7.5 m @ 1.92 g / t gold and 11 g / t silver (14MAHB - 1) was recorded from
drill hole 14MAHB - 13 located approximately 500 meters to the southeast of
drill hole 13MAHB - 1 along a parallel structure.
Perhaps the most interesting geological result has been the detection of a 43 meter
wide section of stockwork exhibiting sphalerite and galena in
hole SJ17 - 006 along the northeastern most section of the Phase 1
drill program.
It comes with wall protecting design and separate extensions (4 and 6 inches), so you can adapt the gate to expand up to 44 inches
wide without having to
drill any
holes in your wall, thanks to the pressure mounted attachment.
To collect a few milligrams of his bone powder for analysis, scientists in the Natural History Museum's ancient DNA lab
drilled a tiny, 2 mm
wide hole into the ancient skull.
Producing a
hole of about 50 centimetres —
wider than those of either SUBGLACIOR or the UK RAID — it is the only rapid
drill that can extract rocks from the bottom of a core.
The deposit there is about 1,500 meters long by 100 meters
wide (about a mile long and 300 feet
wide), but Nautilus can not say how deep it is — except that in many places it is deeper than the 20 - meter (about 65 - foot) exploratory
holes that the company has
drilled into it.
The
drill hose dangled 2,480 feet down a 20 - inch -
wide hole in the ice.
Scientists need to figure out how practical and how expensive it will be to
drill a 43 - centimeter -
wide hole that deep.
After anesthetizing the children, the researchers
drilled six 2 - mm -
wide holes in their skulls.
To that end, Owens Products makes a
wide array of custom fit bracket kits that (where applicable) are designed to use your vehicle's existing factory
holes, so no
drilling is required.
The former are now covered by small
drilled holes, rather than one large opening, while the latter is a replacement for the
wide, 30 - pin dock connector of old.
installing an EGS plant typically involves
drilling a 10 - to 12 - inch -
wide, three - to four - kilometer - deep
hole, expanding existing fractures in the rock at the bottom of the
hole by pumping down water under high pressure, and
drilling a second
hole into those fractures.
Before assembling the legs,
drill pocket
holes for 3/4 ″
wide material in the top of the legs and leg sides.