Sentences with phrase «to run the engine»

The phrase "to run the engine" means to start and operate a machine or vehicle. It refers to the action of getting the engine going so that it can perform its intended function. Full definition
Then run the engine for as long as it takes for the leaks to return.
It is either lack of oil changes, running the engine with too little oil, or using the wrong oil.
Do not run the engine in an enclosed area or partially enclosed area without ventilation.
Running the engine on worn and dirty oil can lead to major troubles.
So, even if your electrical system could handle it (and it almost certainly can't), the starter won't run the engine backwards.
Lots of things can go wrong and cause the simple heat of running an engine to start a fire or at least make things very smoky and scary for a while.
Before you store that equipment, run the engine until it's out of gas, he advised.
Running the engine low on oil will cause many problems.
More than likely running your engine without oil has contributed to an early failure of your engine.
A bad fuel pump can lead to a rough running engine because it is not getting enough fuel.
What exactly are all of the disadvantages to running an engine when the engine coolant becomes too low?
As far as design, I think it has to do with creating such a high power and clean running engine.
I found the 2.4 - liter to be a quiet, smooth - running engine under most driving conditions.
Running the engine helps to get any air bubbles out of the system.
Yet the smooth - running engine pulls hard and gives the sedan responsive performance at all speeds.
Still a strong running engine, great in the snow.
Sometimes people run the engine before the customer gets there so they don't see the black smoke on start up or hear the knocking.
This can be causes by the mass air flow sensor running the engine lean or if you do not have a flex fuel vehicle then running a...
This can trigger the Reduced Power light as well as lead to a poor running engine.
After all, having four cars run its engines would be a big benefit to development.
Now that you know at what operating conditions your vehicle is most efficient the difficulty then becomes running your engine in those conditions at all times during acceleration.
After you do any work involved with draining the coolant you will either have an exact process to remove air from the cooling system or you will simply run the engine.
If you are going to run your engine right away after assembly, you can use oil.
Today, there are some amazing mobile phones that can run our engine well and that will increase significantly as time goes by.
With modern cars, it is more likely that you will get stuck rather than your car breaking down, so why not be able to run the engine for more heat?
The only thing more efficient at being inefficient than this zero - mpg activity is to put the car up on blocks and run the engine with a brick on the accelerator.
You can only run an engine in the red for so long, and it starts to come apart.
Running the engine low on oil may cause problems.
It could be anything... bad motor mount, loose exhaust pipe, rough running engine, transmission mount, etc..
The smooth - running engine pulls strongly in first, second and third gears.
By running the engine at low load or idle, the circulation of the oil and coolant helps to even out this heat distribution, avoiding «hot - spots» - then when you switch it off, the engine cools more evenly, reducing the risk of things warping.
As the other answers say, the engine will idle high to start with, as the ECU compensates for the colder block and thicker oil by running the engine richer.
If the temperatures are present, run the engine again and check how the AirCon is working inside the vehicle.
It was my first oil change with a Harley and my instruction - book (manual) told me to fill 2.8 Liters in it after running the engine for «some time» and draining all oil.
You are running the engine through more revolutions that you would have done if you had used your brakes.
This clean - running engine meets LEV3 - AT - PZEV (SULEV30) / Interim Tier3 Bin30 emission standards, while contributing to the Accord Hybrid's total system output of 212 horsepower.
I heard a rumor about dodge running the engine dry for a few seconds during an oil change for my old truck.
Honda also equips this engine with its variable cylinder management technology, which runs the engine on three or four cylinders under light loads, such as cruising down the freeway.
If your Corolla consumes engine oil, check the oil level more often, as running the engine low on oil can cause serious problems.
The smooth - running engine makes a serious snarl as it revs, underscoring the performance nature of the car and giving it plenty of character.
Generally you would run the engine only when you're draining / flushing the system because this will eliminate any air that still exists within it.
You've got somebody steering and somebody running the engine and somebody bailing.
I loved running the engine up to the redline, but it's difficult to find a place that lets you bang off more than a shift or two at full throttle on a public road.
As juhist said, never run the engine without the battery attached.
You should always wait a minute before checking your dipstick level after running the engine however.
I did notice a smoother running engine and more power after the first bottle of Techron though.
a b c d e f g h i j k l m n o p q r s t u v w x y z