Sentences with phrase «piston rods»

The dampers have new piston rods to reduce friction for more efficient control which translates into a feeling of greater body control with better bump absorption.

It's also true that they separate on the shelf if stored vertically, piston rod up or down.

Obviously though if the shocks have damaged piston rods, valves or they've been leaking gas / fluid then they'll need replacing.

Loose connector pin on piston rod.

Both the front and rear shock absorbers get an increase in piston rod diameter and the rear stabilizer bar's stiffness is decreased.

H22A piston rod length was 143 mm, the bore was 87 mm, and their compression height was 31 mm.

It's easy to load and easy to dispense with the smooth piston rod, included, seal puncture tool, and built - in spout cutter.

This is a powerful machine thanks to the huge drive gear and notched piston rod.

if it is a very loud and continuous knock, one possibility is worn piston rod bearings.

The length of piston rods was of 162 mm, and the compression height of the piston was 30 mm.

Titanium piston rods, an intake system specially developed by GEMBALLA, three intercoolers and a special turbo configuration ensure GEMBALLA pleasure for a long time to come.

Gabriel's strut boots provide piston rod protection and prevent strut damage by bottoming out.

The lightened aluminum pistons and forged piston rods were also used.

The new pistons were applied, while the metal - ceramic piston rods remained the same.

Feature a hardened, chromed piston rod that provides an ultra-smooth corrosion - and scratch - resistant surface, increasing seal life

Also the new piston rods and adjusted crankshaft were applied.

there is another choice: You can locate the bad cylinder and then remove the valve spring, take out the piston rod, wrap a rag around it and hammer it gently on a steel or smooth concrete surface to straiten out the Push Rod a bit for re-use.

So now that I'm getting ready (soon:)-RRB- to fit new pistons in my old Skoda Estelle engine, I found that the piston rods have «wire» C clips.

When you stall the car, the rod bearings get pushed up against the crank shaft and piston rods.

Weight savings are generated by using lighter materials instead of steel parts in the piston rod, internal parts, and module assemblies on the one hand, and with the integration of functions on the other: The newly designed plastic components make previous heavy steel components like the spring cap unnecessary.

Thanks to the design of its interior, friction has been reduced on the piston rods, giving better fuel consumption and engine performance - also enhanced by its valve mechanism and electronic management.

The cooling of the cylinder heads, control times and strokes of the intake camshafts, the pistons, their spray oil cooling and the piston rods have been adapted to the high - performance concept.

I drove a vehicle that had 250,000 miles on it until it threw a piston rod.

The piston rods will bend, and you'll end up with a blown engine.